run show msdp sa
The run show msdp sa command displays the (S, G) entries cached on MSDP peers.
Note: Use this command only on MSDP peers.
Command Syntax
run show msdp sa [ip <ip-address> | detail]
Parameter
Parameter | Description |
ip <ip-address> | Optional. Specifies the address of a multicast source. If this parameter is not specified, (S, G) entries from all the multicast sources will be displayed. The address is in dotted decimal notation. |
detail | Optional. Displays detail information about (S, G) entries cached on the device. |
Example
View the brief information about all (S, G) entries cached on the device.
admin@Xorplus# run show msdp sa
Source Group RP Local SPT Uptime
200.200.200.2 237.0.0.2 3.3.3.3 n y 00:15:17
200.200.200.2 237.0.0.3 3.3.3.3 n y 00:13:35View the detail information about all (S, G) entries cached on the device.
admin@Xorplus# run show msdp sa detail
SA : (200.200.200.2,237.0.0.1)
RP : 3.3.3.3
Peer : 3.3.3.3
Local : no
SPT Setup : yes
Uptime : 05:27:01
State Timer : 00:02:34
SA : (200.200.200.2,239.255.255.250)
RP : 3.3.3.3
Peer : 3.3.3.3
Local : no
SPT Setup : yes
Uptime : 06:04:55
State Timer : 00:02:34View the detail (S, G) entries information of a specific multicast source cached on the device.
admin@Xorplus# run show msdp sa ip 200.200.200.2
SA : (200.200.200.2,237.0.0.1)
RP : 3.3.3.3
Peer : 3.3.3.3
Local : no
SPT Setup : yes
Uptime : 05:27:33
State Timer : 00:03:02
SA : (200.200.200.2,239.255.255.250)
RP : 3.3.3.3
Peer : 3.3.3.3
Local : no
SPT Setup : yes
Uptime : 06:05:27
State Timer : 00:03:02